CERESIT CR 64 SMOOTHING PLASTER 'OFF WHITE'

CERESIT CR 64 adheres to all solid, load-bearing, clean, dry and damp substrates, free of substances that may impair adhesion. Any dirt and layers of weak strength must be completely removed, as well as anti-adhesive substances and paint coatings. Pre-wet brickwork until the surface is no longer absorbent and appears to be slightly dump. Very dry and highly absorbent substrates prime with CT17 deeply penetrating primer and wait for drying minimum 2 hours. Non-absorbent, very smooth surfaces should be primed with CT 19 contact primer before applying CR 64.

Pour the material into a pot with measured amount of approx. 6 l clean, cool water and mix with a low speed mixer until a homogeneous mass without lumps is obtained. After stirring leave material for 5 minutes maturing time and stir briefly again. The plaster prepared in this way should be used within 2 hours. The addition of water depends on the required consistency. 

Use CR 64 only in dry conditions and at temperatures of +5°C to +30°C and below 80% relative humidity. Do not mix with other materials, additives or binders. Do not use on gypsum-based substrates or cover with gypsum-based products. All data given was obtained at an ambient and material temperature of +20°C and 65% relative humidity unless specified otherwise. Protect skin and eyes. For professional users.