-
Low shrinkage
-
Waterproof. Inside & outside use
-
Resistant to frost and de-icing road chemicals
-
Fast hardening
-
Hydrophobic
-
Reinforced with fibers minderal
CERESIT® CD 26 mortar can be applied manually or mechanically, both on vertical and horizontal surfaces. CD 26 is a part of concrete repair system CERESIT PCC, designed for filling cracks/voids, re-profiling balconies as well as for making the complex repairs for various types of cement and reinforced concrete structures. It allows repairing the structures, even when they have been severely damaged due to exploitation or destruction under the influence of mechanical or corrosive factors. Available pack size: 25kg
CERESIT CD 26 adheres to crack-free, load-bearing, clean concrete substrates free from any substances, which may impair adhesion. The substrate should have sufficient compressive strength (concrete class above C12/15) and pull-off strength of minimum 1,0 MPa.
Use CERESIT CD 26 only in dry conditions, the temperatures from +5 to +30°C and relative humidity below 80 %. The mortar should be protected against too fast drying caused by the strong insolation, draughts, etc. The mortar should be protected against rain until it dries completely. Then it is recommended to use the scaffolding protection. Fresh stains should be washed with water, whereas the hardened ones should be removed only in a mechanical manner.
Preparation of the mortar: The content of the packaging should be poured to the measured amount of clean water and mixed with the slow rotating drill with a mixer until the homogenous mass without lumps is obtained. Then it is necessary to wait 3 minutes and mix the mortar once again.Application of the mortar: Within the pot life the ready mortar should be applied with the trowel on the freshly applied contact layer or poured to the form and it should be properly structured. In case of larger areas it is advisable to use vibration scantlings. The surface of the filler should be smoothed with the steel trowel or with the plastic trowel or sponge within approximately 10–20 minutes.
CERESIT CD 26 is a part of concrete repair system CERESIT PCC. CERESIT PCC system is designed for filling cracks/voids, re-profiling balconies as well as for making the complex repairs for various types of cement and reinforced concrete structures. It allows repairing the structures, even when they havebeen severely damaged due to exploitation or destruction under the influence of mechanical or corrosive factors.
CERESIT CD 26 may be applied both on vertical and horizontal surfaces inside and outside the buildings. The mortar can be applied manually or mechanically. The mortar can be applied on the concrete of the class above C12/15.
Use CERESIT CD 26 only in dry conditions, the temperatures should range from +5 to +30°C and relative humidity should be below 80 %. The mortar should be protected against too fast drying caused by the strong insolation, draughts, etc. The mortar should be protected against rain until it dries completely.