- Excellent self-levelling properties
- Resistant to castors
- Suitable for joint-free heated floors
-
Excellent self-levelling properties
-
Resistant to castors
-
Suitable for joint-free heated floors
-
Not suitable on a wearing surface
-
Environmentally compatible
CERESIT® DG self-levelling compound is used for levelling horizontal concrete, cement-sand, sand asphalt and other (mineral) substrates, including heated ones. The compound is applied as a substrate for floor coverings in dry indoor areas. Do not apply CERESIT DG in layers exceeding 3 to 30 mm per application. When a layer thickness of 30 to 80 mm is required, mix CERESIT DG with 30% aggregate (sand). Do not use CERESIT DG for producing industrial floors. Only for indoor use. Available pack size: 25 kg
Before application of CERESIT DG make sure to prepare basis. Basis shall be solid, thick, clean and dry, without any visible damages.
Dry mixture is to be tempered with exact amount of clean cold water (+15 to +20 °C) – 5.5 l to 6.0 l per 25 kg of dry mixture. Dry mixture is gradually poured in water and stirred to a smooth paste without balls with the help of a low speed stirrer.
Then a 3 min technological break is to be done for preliminary maturing of the mixture and stir it again. The surface of the freshly-poured mixture is to be rolled with a needled-roller for removing air bubbles. Turbo-pump or screw pumps might be used for mixture pouring.
The compound is applied as a substrate for floor coverings in dry indoor areas. Do not use CERESIT DG for producing industrial floors. Only for indoor use.
CERESIT DG can be used on suitable:, mineral screeds, tiles and slabs, concrete, natural stones and terrazzo, epoxy resin coatings.
Only carry out floor installation work if the floor temperature is above 5 °C, air temperature above 25 °C and relative humidity below 75 %.